Starlight staff is producing 3 phase synchronous generator rotor. Each of rotor part is made Starlight company. Rotor is made of copper wires. We pay attention to generator quality and insist on providing customer with high performance products.
Patented
rotor coil wires, structure with triple-insulated treatment:
Bottom: lapped tapping of Class H insulation film;
Middle: insulating glass wrapping;
Outside: immersion and drying of high quality insulating paint;
Effectively improve the insulation between rotor’s different bundles
and different layers, and effectively enhance the moisture-proof and
anti-corrosive ability, and also effectively improve the life, reliability,
environmental adaptability of the generator accordingly. Especially to adapt to
the bad environment such as high heat and humidity, subtropics, island,
chemical industry, textile, etc.
3)
Advantages of adoption of patented rotor wire:
If ordinary enameled wires are used to wind the rotor, it could easily
cause short circuit between bundles and layers which result from the painting
cracks and falling off. This kind of fault is a major cause of the damage of a
generator. By comparison in said experiment, due to the special structure, the
flat copper wires which adopt the amido film half-lapped tapping and glass fiber
lapping absolutely will not lead to problems and hidden dangers because of
insulation layer during the winding.
Generators
use Brushless self-excitation automatic voltage regulation system:
Use the fundamental wave and third harmonic at the same time as the
excitation power to supply excitation, build stable output voltage with an
excellent dynamic performance, give a consideration on the function of built-in
sudden loading buffer of the fully plastic-filmed electronic AVR module
(LAM) working under bad environment.
Comments
Post a Comment